If its not the spring turn the icemaker off (some have a switch and some you will have to unplug) for at least 30 seconds. Then turn it back on and press in on the feeler arm three times within 15 seconds of turning the icemaker back on. If done correctly the icemaker will go through a cycle and run water.

Beside this, how do I reset my GE ice maker?

How to Reset the Ice Maker on a GE Side by Side Refrigerator

  1. Locate the shut-off switch on the front of the GE refrigerator ice maker and turn the switch off, leaving it off for at least 30 seconds.
  2. Turn the switch back on and locate the feeler arm on the ice maker.
  3. Push the feeler arm up three times quickly to reset the ice maker.

Also, how do you troubleshoot an ice maker? Ice Maker Troubleshooting Guide

  1. Check the shutoff arm.
  2. Check the supply valve.
  3. Inspect the water supply line.
  4. Test the shutoff switch.
  5. Check the freezer temperature.
  6. Inspect the ejector gear.
  7. Test the ejector motor.
  8. Test the ice mold heater.

Consequently, why isn't my GE ice maker working?

If the water inlet valve is defective, or if it has insufficient pressure, it won't allow water to flow through. As a result, the ice maker won't make ice. If the water inlet valve has sufficient pressure and is getting power, but the ice maker won't fill with water to make ice, replace the water inlet valve.

Is there a reset button on a GE refrigerator?

Unfortunately, there is no easy reset button so the computer must be reset manually. To reset your refrigerator: Unplug the refrigerator from the power source or turn off power at the circuit breaker.

How long does it take a GE ice maker to cycle?

On a new installation, the icemaker will not start immediately after being plugged in, since the icemaker must reach a temperature of approximately 15 degrees F. before a cycle is initiated. Please allow up to 24 hours for the icemaker to begin cycling. See also New Icemaker Not Producing Ice.

How do I reset my ice maker?

Look for the Reset Button Once you do that, you should see the bright red reset button on the bottom of the ice maker itself. To reset the ice maker, push this button in and hold it for 10 seconds. You can release it sooner if: The ice maker starts making noise and operating.

Do all French door refrigerators have ice maker problems?

Many French-door refrigerators come with a through-the-door ice and water dispenser. But icemakers are a common failure point on refrigerators, so models with an ice dispenser tend to be more repair-prone than those without it.

Can water filter cause ice maker not to work?

However, the issue may be connected. In some refrigerator models, the water line that supplies the ice maker and water dispenser connect through the same water filter. If the filter is clogged, water can't get through to create ice.

How long does it take a GE ice maker to make ice?

If the icemaker was installed but the water line was not added until later, once the water and icemaker is turned on the icemaker will cycle within a few minutes and fill and process its first cubes in about 1 1/2 hrs. The icemaker is dependant upon the temperature in the freezer.

How do I reset my GE Profile water filter?

Resetting the Filter Light The water filter warning light or message is reset by pressing the Ice & Water pad on the control panel for three seconds. The filter light should turn green, and the filter status will show Good.

How long does it take a GE refrigerator to make ice?

6 to 12 hours

Why is my GE freezer not making ice?

If your icemaker is not producing any ice: The icemaker must reach 16 degrees F before a cycle will begin. If the temperature in the freezer is too warm, ice cubes will take longer to form or may not form at all. Try adjusting the freezer temperature.

How do I know if my ice maker is bad?

If the ice maker makes cubes and kicks them into the bucket – the water inlet valve is bad. If there are no new cubes in the bucket – the ice maker is bad.

How do I unclog my ice maker water line?

  1. Shut off the water valve that feeds that water-dispenser and ice-maker lines.
  2. Remove the ice bin and dump the ice out in the sink.
  3. Pour 3 to 4 cups of white distilled vinegar into the ice-maker and dispenser lines with a small funnel and allow it to soak for five to 10 minutes to break down the lime.

Why does my ice maker not fill with water?

If the water inlet valve is defective, or if it has insufficient pressure, it won't allow water to flow through. As a result, the ice maker won't make ice. If the water inlet valve has sufficient pressure and is getting power, but the ice maker won't fill with water to make ice, replace the water inlet valve.

What causes ice maker to freeze up?

A refrigerator ice maker that freezes up can be caused by a frozen ice maker fill tube, faulty water inlet valve, too low freezer temperature setting, or a water filter that needs replacing. First, locate the water supply to your ice maker and turn off the water supply via the shut off valve.

Why is my Samsung freezer not making ice?

If the water inlet valve is defective, or if it has insufficient pressure, it won't allow water to flow through. As a result, the ice maker won't make ice. If none of these parts are at fault, and the freezer temperature is at least 15 degrees Fahrenheit, replace the ice maker assembly.

Why has my Samsung freezer stopped making ice?

If the ice maker appears to not be making any or enough ice, low water pressure or a faulty water filter may be to blame. When the ice maker makes small, cloudy, or clumped ice, it could be something as simple as a dirty water filter, low water pressure, or high mineral deposits in your water.

How does the ice maker work on a GE refrigerator?

Fill: A switch opens a solenoid water valve and lets in just enough water to fill the ice mold. Freezing cycle: The icemaker has a built-in thermostat which monitors the temperature level of the water in the molds. After the cubes are ejected, the arm drops down again (or pushes out) to sense the ice.

How much does it cost to fix an ice maker?

A typical ice maker costs between $60 and $200 to replace, Daganaar says. Some of the factors that affect price include accessibility of the components and the brand.

Why isn't my Frigidaire making ice?

A common issue for a Frigidaire refrigerator ice maker not making ice is a clogged water filter. Before water goes to the ice maker or water dispenser, it flows through the filter to get rid of any impurities. Over time, the filter will reach it's capacity and will clog up, restricting water flow.